Qingdao Chaoyue Artificial Grass Co.,Ltd
Home > Exhibition > Content
Standard for construction of artificial grass
- May 22, 2017 -

1.basic acceptance: before the construction of the buyer, the foundation must be clean, no debris, such as the foundation needs rectification, must be put forward to the customer rectification.

2.site line: Line strictly according to drawing size, size error is less than 10 mm.

3.SOD paving: strictly according to the requirements of the plot put SOD, according to the same direction spread out, keep SOD consistent.

4.the turf cutting: the turf can be used to cut paper cutter, cutting, the joint shall be used when artificial grass special push knife seam cutting, and ensure the bottom of the distance from the edge of the grass line distance from the root of the control in 2-5 mm.

5.joint standard: turf joint gap width is less than 1 / 2 artificial grass spacing, spacing between joints on both sides of the two cursive of not more than 1.5 times the spacing of artificial grass..

6.bonding glue respectively and evenly at the bottom and connected with artificial grass, and cool 15-30 minutes after the start of the bond, combined with the special rubber hammer beat again, according to the degree of wet glue or artificial stampede three times without loss, or rolling 1-2 tons of automobile tires once, there shall be no debonding seams.

7.the amount of glue: such as the use of long card artificial grass, strictly control the construction of standard glue dosage: 55 ~ 60 meters / barrel seams, basic frizz and smoothness will be appropriate to increase the amount of.

8.function: to ensure the function of embedded line line, straightness deviation is not greater than 5 mm, perception without bending.

9.the outer edge of turf cutting: cutting smoothly, on the basis of transition part of no obvious bump phenomenon.

10.Shi Eisa: must use standard bagged dry quartz sand, according to the amount of RBI per square meter evenly placed, with artificial uniform spreading, 32 mm and above an area of more than 2000 square meters of the site, the use of professional turf grass carding machines. The rest of the site can be used for artificial turf rake comb, filling evenly, no obvious concavity.

11.note: must use a standard bag of rubber particles and dry rubber particles, according to the amount of RBI per square meter evenly placed, with artificial uniform spreading, 32 mm and above an area of more than 2000 square meters of the site, the use of professional turf grass carding machines. The rest of the site can be used for artificial turf rake comb, filling full, no obvious concavity.

12.grass silk carding rate: the use of professional comb machine comb grass, should be vertical and horizontal direction of cross combing many times, such as filling and site dry, grass yarn comb rate of more than 95%. If the filling and site are wet, the rate of grass combing is over 85%.